The Process Of Installing An Underground Dog Fence

 

Most people to install an underground dog fence to avoid paying the pet stop controller. There is a process that should be followed to get the right installation. The first process is installing a dog fence controller to test if all is working. The controller should be located close to a power outlet and prevented from elements. The controller box should be attached to the wall and a small hole drilled through the wall. The twisted wire that is bought together with the system should be run outside the perimeter of the entire property. The wire that runs with the single strand wire around the property that joins each end of the single strand to the twisted pair of the pliers that are provided in the kit. The system should be switched on to test whether the connection was made appropriately and if it is working.

 

The second procedure is burying the connected wires in the ground. One can choose to use a trencher with a cable laying attachment. This cuts through the soil and lays the boundary wire and then backfills. One can decide to rent a trencher from the stores to save on time that will be used. The boundary will be fed through the trencher and tie one end of the wire to stake in the ground. The trencher will then be engaged to the blade and driven around the entire property. Once the wires are buried, one should connect the system once again to check if everything is working. Read dog product reviews here!

 

The final process is setting up the dog containment system. The Dog fence controlled will have a dial to let you adjust the width of the field. This will control how far from the boundary wire the collars start beeping and delivering the correction. The width of the field should be adjusted so that the distance between the fields is between a maximum of two yards. When the field has a bigger width will reduce the playing space of the dog and ensure the safety of the dogs is maintained. Get buying guide here!

 

Any dog owner who has stubborn dogs should strive to have a wider field. If you have a bigger yard, you can also consider getting the wider field for the dogs. If one has dogs that are compliant and follow instructions one should have a smaller width on the field. The edges should then be marked at the edge of the field with the flags. The system should be checked to determine if the collar will beep when you move past the flags. If the collar beeps once you pass the flags that are an indication that the installation was successful. For additional facts and information about dog fences, you can go to https://en.wikipedia.org/wiki/Dog.